Please review our frequently asked questions. If there is something more specific that you are looking for, then please contact us directly.

By pressing [SALT TEST] a salt measurement is taken, and a total TDS reading is displayed. The ideal TDS reading should be an LCD display of “OK”, approximately 3000-4000ppm. If “HIGH” is displayed, the salt level is above 4500ppm and the salt level is too high, and if “LOW” is displayed the salt is below 1000ppm and we suggest taking a sample to your local pool Professional for a more accurate result and further assistance. For the FRESHWATER/ULTRA LOW SALT SYSTEM Models: VP25LS and VP35LS, the TDS reading is 1200-1800ppm. Click here to view how

If you need to change the time on your Vapure Chlorinator you can do so by pressing the Timer button, this will ask you if you want a single or dual cycle, if you press the Timer button again, it will allow you to simply change the time of day. Use the arrow keys up or down to change the hour and press “OK” to save, update the minutes and again press “OK to save the selection. Click here to view how

You can use an external controller with a Vapure Saltwater chlorinator. To do this, set your timers in dual or single cycle to turn on and off at 00:00, and turn the Vapure Chlorinator “ON”.

This is a very rare problem, but if it does occur, simply turn off the power point and unplug the chlorinator power plug from the wall, re-plug in the power and turn the chlorinator back on. The temperature should once again be displayed.

To extend the life of the LCD display, the display will become dim after 2 minutes of inactivity. Any time you press the keypad, the LCD will become bright again, and automatically dim once the activity has stopped after 2 minutes.

A red flashing light on your chlorinator indicates there is a fault and you should act. The most common fault is a flow fault where there is insufficient water flowing over the cell. This can be remedied by ensuring that there is sufficient water in the pool and that all oring’s are greased and there are no cracks in pipe or fittings. Other faults include high or low temperature and high or low salt. Please consult your manual.

Product Brochure

CAS Vapure Series Salt Water Chlorinators Brochure

Install & User Guide

Installation & Operting Instructions for CAS Vapure

Training and Support
Training and Support

Learn more about using our products